How to Install the Hob
How to install the hob:
Overall dimensions of the hob: Width: 585mm Depth: 500mm
Worktop cut-out dimensions:
Width: 550mm Depth: 470mm
1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood
to ensure that you will have the required clearance. The cut-out (Fig.4) shows a 60mm gap from the wall to the cut-out
edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to be fitted,
take this into account when cutting the hole. The minimum distance that the hob should be positioned away from the rear
wall or splashback is 50mm.
2. Position the hob seal, as shown in Fig.6, ensuring that the ends meet without overlapping. Do not use silicone type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in Fig.7. Remove any excess sealant
after tightening the brackets. Do not over-tighten the fixing brackets.
3cm
4cm
65mm
470mm
550mm
150mm
150mm
Fig.4
Fig.5
400mm
650mm
185mm
185mm
60 mm
470 mm
550 mm
190 mm
190 mm
Fig.6
Fig.7
8