16
Changing the light bulb
Disconnect the appliance from the power.
•
Carefully remove the light cover by pushing in the lever at the back
of the cover, and then pulling the cover down.
•
Unscrew the light bulb to remove it and replace with a new bulb
(max 15W).
•
Replace the light cover and reconnect the power after five minutes’
delay as explained on page 9.
Troubleshooting
If you have any problems with your appliance, you should check
the troubleshooting prior to calling CDA Customer Care to prevent
unnecessary service calls and potential cost.
If the appliance is not working
•
Check there is power to the appliance:
•
The house fuses are intact and the fuse in the plug has not blown.
•
The thermostat is not set to 0 (off position).
•
The plug socket is functioning fine. To check this, plug another
electrical appliance in to see if the socket is working.
•
The temperature of the room is adequate (16°C or above).
The appliance is working, but not very well
•
The appliance is not overloaded.
•
The thermostat is set to an appropriate temperature.