9
Troubleshooting
Please note:
Your extractor is equipped with a motor protection device that will
switch off the motor to prevent damage from overheating. This may
happen during cooking when most or all of a hob’s zones/burners are
being used simultaneously, or if your extractor is installed incorrectly
(e.g. lower than the recommended height).
This is normal, and the extractor will work again once the motor has
cooled sufficiently.
If your extractor is not working:
1. Check that the mains supply has not been switched off.
2. Check that the fuse in the spur has not blown.
3. Check that a speed switch is active and the canopy is open.
If your lights are not working:
1. Check that the mains supply has not been switched off.
2. Check that the fuse in the spur has not blown.
3. Check that the lamp switch is on and the canopy is open.
4. If the extractor still extracts, then it’s possible both bulbs have gone.
The bulbs are 3W E14 (SES) LEDs.
Contact CDA Customer Care
A
: Customer Care Department, The CDA Group Ltd, Harby Road,
Langar, Nottinghamshire, NG13 9HY
T
: 01949 862 012
F
: 01949 862 003
E
W
: www.cda.eu
