CDA CCA51, Инструкция по установке, эксплуатации и обслуживанию

Страница: 8 / 20

8
2. Take a note of the position of the securing wires holding the
filter in place, with a photograph on a smartphone or similar if
necessary, so that they can be replaced in the same position.
Lift the filter retaining wires from the cover panel.
3. Remove the grease filter and wash by hand in a lukewarm solution
of water and mild detergent. Once clean, dry the grease filter but
DO NOT wring it out. Clean the filter holder using a dilute solution
of water and mild detergent or with a damp cloth. Allow the grease
filter to dry completely before reassembling the extractor panel.
4. Replace the grill panel and refasten the sliding brackets.
5. Replace the grease filter in the cover panel and reattach the filter
retaining wires.
Please note:
The extractor must not be used without the grease filter in place.
Changing the charcoal filter
To ensure best performance of your extractor, you should replace the
charcoal filters every four to six months, depending on use. Please
note the charcoal filter cannot be washed. To attach a new charcoal
filter, follow the steps below.
1. Unfasten the securing screws (S in Fig 2 on page 7) on either side
of the cover panel and the cover panel will come off. Take care
not to drop it.
2. Remove the old filters using a small posi-headed screwdriver and
fit the new charcoal filters in their place using the screw you just
removed. Diagrams (and info) are on page 17.
Replace the cover panel and refasten the securing screws.