MOUNTING INSTRUCTIONS
Due to the narrowness of the laser beam, alignment is critical and
because of This the units must be attached to a rigid mounting
surface. Install the receiver on proper place, using a metal mounting
bracket that is provided in the package. There are several options to
mount the system; Mounting the metal mounting bracket on rigid
surface and attach the system using the magnet plate
surface and attach the system using the magnet plate.
When a surface is metal, mount the system directly on a metal
surface. When a surface can be screwed, mount the system using
screws or use Velcro tape if other options are not available Power
screws or, use Velcro tape, if other options are not available. Power
on the transmitter and orient the laser beam to the receiver and find
and mark the exact location where the receiver is placed on the center
of laser beam. Power off the transmitter, before mounting the
transmitter. After mounting the transmitter, power it on and check the
center of laser beam is exactly located on the receiver. To make the
receiver get better signal, adjust the diameter of the circle of laser
beam, turning the laser transmitter to counter-clockwise.
Содержание ELT-L1350
Страница 6: ......
