On setting a private line for a room, if the telephone in the room is lifted, there will be system dial tone for 3 seconds
duration (during which any of the internal numbers can be dialed) and then its private Junction line will automatically get
connected to the room extension. Also incoming calls on this Junction line will land directly at that room.
.
Queued Call
.
This feature enables you to handle more than one incoming call. If you are busy with one call then you will get a warning
tone of second call landing on your extension. The warning tone sound will be heard only once. You can pick up the
queued call by either of the two ways given below
:
To Pick up Queued call
Disconnect the current call by keeping the handset
The queued call rings
Lift handset to start conversation
OR
Park the current call by dialing the Call park code. (With office version)
Keep the handset down
The queued call rings
Lift handset to start conversation
After Conversation, Keep the handset down
Pick up the parked call by dialing the parked call pick up code
The beep tone which you get when a call is queued to your extension can be disabled.
To disable the beep tone
Dial 55 + 777 (Default Extension Password)
Dial 61
Hear Confirmation tone
Keep the handset down
To enable the beep tone
Dial 55 + 777 (Default Extension Password)
Dial 60
Hear Confirmation tone
Keep the handset down
.
Redial
.
For redialing the last dialed Telephone number on Junction line press [REDIAL] key.
Note
:
In case of delayed dial tone from DOT, redial will not work.
.
Ring / Voice Paging
.
(Discontinued)
This feature can be used by any extension that dials a key phone extension number. The calling extension can activate
the speakerphone of the key phone being called and start conversation. The speakerphone gets disconnected as
soon as the caller disconnects. In case the caller does not get a reply on activating the speaker, because of the
absence of the user, then he can revert back to the ringing mode in order to draw the users attention if he is nearby.
To activate the speakerphone when dialing a KTS extension:
On getting a ring back tone
Dial 2
Now whatever you speak will be heard through the base speaker of the KTS
To revert back to ringing mode:
Dial 1
Hear Ring back tone
Note
:
Operator cannot be activated using this feature.
.
Service Extension
.
This feature is workable in Hotel version mode.
One extension on every floor can be programmed as Service Extension and all Extensions of the Rooms can be
attached to their respective Service Extensions.
Every room would dial a common number for Service extension but would get connected to their respective floor wise
service extensions.
This feature is generally used for Room Service purpose.
Refer Programming Manual for its programming.
To call Service Extension (room service):
Dial 87
Wait for answer
