WARNING:
If lava rock or media is wet, allow fire pit to burn for 45 minutes prior to coming
within 15 feet of the fire pit. There should be a minimum of a half inch of media
between the burner ring and the fire plate.
WARNING:
WHEN NOT IN USE THE FIRE PIT SHOULD BE COVERED AT ALL TIMES. This
will prevent precipitation, dirt, leaves, and other debris from entering the fire area.
WARNING:
For remote control use: To prevent accidental start-up from unwanted RF signals, it
is the responsibility of the end user to turn off the power to the electric outlet for the remote
control receiver when the fire pit is not in use via wall switch or breaker.
WARNING
: It is the responsibility of the installer to follow ALL LOCAL CODES concerning the
installation and operation of the fire pit.
ASSEMBLY
Estimated Assembly Time: 15 minutes
Connection plumbing should be performed by qualified person only!
It is the installer’s responsibility to ensure a safe installation, and to educate the end
user as to how to correctly operate the fire pit.
WARNING:
Never alter product or configuration in any way.
Assemble the fire pit on a non-abrasive surface. If necessary to lay unit on its side,
be sure to do so on a padded surface to avoid scratching the face of the fire pit.
This fire pit should arrive with internal plumbing preassembled. If plumbing
connections from key valve up to burner are loose or not connected,
STOP
and
ensure the integrity of the components have not been jeopardized. Then proceed by
correctly securing the flex line to the burner and key valve.
Supply line should enter bottom of unit in precut notch ONLY.
WARNING:
Do not obstruct the vent holes at the base of the unit. Failure to adhere
to this warning may result in serious injury and possible property loss.
Connect supply line to key valve.
START YOUR FIRE PIT
WARNING:
Fire pit should be attended by an adult that is familiar with emergency
shut-off.
WARNING:
Flammable materials should not be placed on or near the fire pit.
