CC-ISOBUS CCI 50, Руководство по эксплуатации

Страница: 350 / 359

CCI.GPS
– Operation
13
Geometry settings
The position of the GPS aerial on the tractor is specified in CCI.GPS. It is very
important that you make this entry as accurate as possible!
Only then is CCI.GPS able to transfer GPS position data referenced to the tractor's
reference point (mid-point of the rear axle) to other CCI.Apps.
Most tractors have several mounting options at the rear. In CCI.GPS , the distance
from the mid-point of the rear axle to the coupling point is entered separately for
four different mountings. So that, for example, the correct distance is used in
CCI.Command , after coupling up of an implement, only the currently used
mounting must be selected. If the settings in CCI.GPS were made carefully, re-
measuring is no longer necessary. (See also the chapter
Geometry from the
CCI.Command operating instructions).
4.4 Geometry settings
In this tab the position of the GPS aerial on the tractor and the distance to the
mounting are displayed and their setting is also possible.
You have the following operating options:
Enter distance A
Enter distance B
Select mounting
Enter distance C