CBA Wireless Vibrating Receiver
4
SECO-LARM U.S.A., Inc.
Replacing the Batteries:
Also Available from SECO-LARM:
1.
Remove the battery cover.
2.
Place 2x AA batteries (not included)
in the battery compartment, making
sure to observe correct polarity.
3.
Replace the cover.
Battery
compartment
Battery cover
Wireless
Outdoor PIR Sensor
RA-4961-DSQ
NOTICE:
The information and specifications printed in this manual are current at the time of publication. However, the
SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LRM reserves the right to
change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors. Trademarks
are the property of SECO-LARM USA Inc. or their respective owners.
Copyright © 2015 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or
in part, without the written permission of SECO-LARM.
LIMITED WARRANTY:
This SECO-LARM product is warranted against defects in material and workmanship while
used in normal service for one (1) year
from the date of sale to the original customer. SECO-LARM’s obligation is limited to
the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty
is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or
alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such
equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole
obligation of SECO
-
LARM and the purchaser’s exclusive remedy, shall be limited to the replacement or repair only, at
SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential
personal or property damage of any kind to the purchaser or anyone else.
SECO-LARM
®
U.S.A., Inc
.
16842 Millikan Avenue, Irvine, CA 92606
Website: www.seco-larm.com
PIHVK1
Phone: (949) 261-2999 | (800) 662-0800 Email: [email protected]
MiRA-4961-VPQ_151001.doc
FCC COMPLIANCE STATEMENT:
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST
ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED
OPERATION. Notice: The changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment. IMPORTANT NOTE: To comply with the FCC RF exposure
compliance requirements, no change to the antenna or the device is permitted. Any change to the antenna or the device
could result in the device exceeding the RF exposure requirements and void user’s authority to operate the device.
Wireless
Alert System
RA-4961-K1Q
Wireless
Magnetic Contact
RA-4961-MCQ
Wireless
Pushbutton
RA-4961-PBQ
Wireless
Indoor PIR Sensor
RA-4961-PRQ
Wireless
Mailbox/Tilt Sensor
RA-4961-MBQ
