Cavium FastLinQ 45000 Series, Руководство пользователя

Страница: 63 / 342

5–Adapter Preboot Configuration
Getting Started
36 BC0154501-00 P
 Setting the Partitioning Mode to NPAR
1
adds the Partitions
Configuration option to the Main Configuration Page, as shown in
Figure 5-4 .
Figure 5-4. Main Configuration Page, Setting NPAR Partitioning Mode
In Figure 5-3 , the Main Configuration Page shows the following:
 Firmware Image Properties (see “Displaying Firmware Information” on
page 38 )
 Device Level Configuration (see “Configuring Device-level Parameters” on
page 38 )
 Port Level Configuration (see “Configuring Port-level Parameters” on
page 41 )
 iSCSI Configuration (if iSCSI remote boot is available) (see “Configuring
iSCSI Boot” on page 45 )
 FCoE Configuration (if FCoE boot from SAN is available) (see “Configuring
FCoE Boot” on page 43 )
 Partitions Configuration (if NPAR is selected as the Partitioning Mode )
(see “Configuring Partitions” on page 47 )
1
The QL456 x 1 (1×100G) adapter does not currently support NPAR mode on Windows.
NOTE
The NPAR option is not available on Cavium 100Gb Intelligent
Ethernet Adapters: QL45611HLCU and QL45631HOCU.