2
Operation guide for speaker system
Basic
The power indicated in the speaker means the power output in the low frequency. When using
it please take care not to increase too much treble or mid-bass, otherwise, the tweeter and
mid-bass are overworked, it will cause abnormal S/N and possible damage the driver units. In
the speaker system, the power indicated for power amplifier is much more than one indicated
in the speakers, this is for the peak music and it is one of basic requirements. Therefore,
please do not set the volume in the maximum, otherwise, it will cause the damage to the
speakers and such damage is not in our warrantee service. Some speakers indicates very
powerful but sounds weak, it may because of low sensitivity. In the same power output, it
would sound much more powerful if speaker has high sensitivity. However, in hi-fi system, in
order to smooth the whole frequency response and reduce the distortion, we may set lower
sensitivity.
Notes
:
1.For special purpose, if you need to connect to non-professional audio device, please
operate it under the professional engineers.
2.The best room for sound pressure testing covers with 15m2 to 40m2, vertical height :
2m~4m
3.All the specification in our speakers is set based on European Unit standard. No special
request for amplifiers and is easy to get it drive.
Placement
:
1.Place the speakers facing the front of listening position, place the left speakers and right
speakers symmetrical;
2.Do not place the speakers side by side. The distance of axis is over 1.5M, it will get better
stereo sound.(Generallyspeaking,it can get the ideal sound if listening position and two
speaker placement positions are put as one triangle)
3.Place the speaker facing the wall with the distance of about 20cm, it will get better bass
delivery. It is ideal if the tweeter are in closed to the height of listening ears of users)
4.Avoid placing this in an area that is exposed to direct sunshine or raining.
HIGH FIDELITY SPEAKER
02
连接方法:
扬声器系统连接方法
1、确定功放机的电源处于关闭状态。
2、确认
FL-30A
后接线板上的两组接线柱之间的连接铜片是将两个正极、负极分别连接好。
3、取出附件里的音箱连接线，从功放的正负极输出接出，正极(+)连接红色端，负极(-)连接
黑色端，线的另一端与音箱的正负极分别连接起来。(见图)
4、最后再打开功放机的电源。
正极端连接柱
功放机连接线
INPUT
INPUT
镀金铜片
负极端连接柱
03
HIGH FIDELITY SPEAKER
FL
-
30A
FL
-
30A