Cattron Remtron Pump Boss II Series, Руководство пользователя

Страница: 24 / 29

Remtron Pump Boss II
User Manual
24
9M02-8814-A001-EN
Version 2.3
Figure 6 :
1.
Install fresh batteries in the Transmitter and press the ‘ON’ switch. The GREEN LED should flash.
2. Switch on the Radio Remote Receiver and check to
see the ‘POWER’ LED is lit.
3.
Press and hold the receiver’s ‘AUTO LINK™’ Touch Pad (switch) and observe that the ‘SIGNAL’ LED
lights up with two short blinks.
4. Locate the transmitter within five
feet of the receiver antenna. Press and hold the transmitter’s red
‘STOP/OFF’ button switch and observe the receiver’s ‘SIGNAL’ LED.
When the ‘SIGNAL’ LED is continuously lit (no blinks), the receiver has ‘learned’ the frequency channel and
address (ID Code) of the transmitter.
Note:
If the receiver’s ‘SIGNAL’ LED does not switch from blinking to solid, the old transmitter ID code will
remain in receiver memory.
5.
Release the receiver’s ‘AUTO LINK™’ switch, followed by the transmitter’s ‘STOP/OFF’ button switch.
The replacement transmitter’s frequency channel and address is now entered in the receiver memory. You may
now proceed with Pump Operation.
Transmitter ‘ON’
switch
Transmitter ‘STOP /
OFF’ switch (Press
and hold during the
‘learning’ procedure
‘AUTO LINK’ switch
(Press and hold
during the ‘learning’
procedure