Cattron-Theimeg LRC-L1, Руководство пользователя

Страница: 9 / 26

User Manual LRC-L1
Version 1.0.0 - 11/2010 Subject to change without notice. 9
4.3 Before turning on
⇒
Verify that the TransKey (black) is placed in the TransKey hollow inside the battery compartment
⇒
Insert a fully charged battery
NOTE
!
Batteries are shipped uncharged!
4.4 Turning the transmitter on (Standard)
⇒
STOP switch must be released and joysticks in Zero-position
⇒
Turn key switch to ON position 'I'
⇒
Status LED lights briefly red, then flashes green
⇒
The transmitter is turned on
NOTE
!
After the transmitter has been turned on, the safety relays in the receiver unit should be energized
and the receiver should be able to respond to commands initiated by the transmitter.
4.5 Turning the transmitter on with STOP switch check (only when requested by customer)
The transmitter can be configured so that for turning on the unit, the STOP switch must be activated once
before the transmitter goes into operation.
⇒
STOP switch must be released and joysticks in Zero-position
⇒
Turn key switch to ON position 'I'
⇒
Status LED lights red
⇒
Activate the Stop switch (Status LED light orange) and release within 10 seconds
⇒
Status LED flashes green
⇒
The transmitter is turned on
NOTE
!
After the transmitter has been turned on, the safety relays in the receiver unit should be energized
and the receiver should be able to respond to commands initiated by the transmitter.
4.6 Turning the transmitter off
⇒
Turn the transmitter off by bringing the key switch into the '0' position
NOTE
!
After the transmitter has been turned off, the safety relays and all other relays (in case of a relay
interface) in the receiver unit will be de-energized and the receiver will not be able to respond to any
commands initiated by the transmitter.
4.7 STOP Command
In the event of a dangerous situation, a STOP command can be initiated by pressing the STOP switch.
⇒
Press the STOP switch
⇒
Receiver unit is turned off
⇒
Transmitter unit is turned off
NOTE
!
After pressing the STOP switch, the safety relays and all other relays (in case of a relay interface) in
the receiver unit will be de-energized and the receiver will not be able to respond to any commands
initiated by the transmitter. The transmitter unit is turned off.