13
CARE AND CLEANING
CARE AND CLEANING
Before cleaning the appliance, always
disconnect the plug of the power cord from
the mains socket and wait for the slicing disc
to come to a full standstill.
Turn the cut thickness control to 0.
Clean the appliance after each use to avoid
the build-up of deposits.
For cleaning, please use only soft sponge
slightly moistened in warm water. We
recommend the use protective gloves
resistant against being cut through.
Wipe the appliance with a soft sponge
slightly moistened in warm water, then wipe
with a soft sponge.
WARNING!
DO NOT WASH THE
APPLIANCE, MAINS
CORD AND PLUG
UNDER RUNNING
WATER AND DO
NOT IMMERSE IT
IN WATER OR ANY
OTHER LIQUID.
ATTENTION:
Do not use sharp objects, chemicals,
thinners, petrol or other similar
substances. Under no circumstances
should the appliance be cleaned with
a steam cleaner.
CLEANING THE REMOVABLE HUB
If the slicing disc hub is excessively dirty, you
can remove and clean it.
Carefully loosen the slicing disc hub fi xing
screw. Hold the slicing disc hub with your
other hand and once the screw is loosened,
remove it from the appliance.
Wash the hub in warm water with a small
amount of kitchen washing-up liquid,
rinse and wipe dry. Before assembling your
appliance, make sure that the slicing disc hub
is completely dry.
Wipe the slicing disc with a soft sponge, then
wipe dry with a clean cloth.
Insert the hub onto the slicing disc and
secure with the fi xing screw. Tighten
thoroughly.
GREASING THE PRESSURE PLATE
If the pressure plate stops moving, it may be
necessary to grease the rail at the appliance
bottom along which the plate moves.
1. Before greasing, make sure that rotary
cut thickness control is set to 0, the
appliance is turned off and the power
cord is unplugged from the mains socket.
2. Tilt the appliance carefully, leaning it
against the slicing disc hub fi xing screw.
We recommend to insert a cloth under
the fi xing screw to avoid damaging or
scratching the countertop.
3. Wipe the rail attached to the pressure
plate.
4. Use a common lubricant or oil suitable
for this type of appliance.
GRINDING THE SLICING DISC
If the slicing outcome is not satisfactory,
the slicing knife may be blunt. Use only the
supplied slicing disc grinding attachment for
grinding.
