3
Utilisation
Use
Utilizare
Kullanım
Before you start
• 2 x 1.5V AA (LR6) size batteries required. Batteries are not included.
• Decide on an appropriate location for your product (see siting instructions below).
• Take care not to damage or twist the wires when removing from the packaging.
• Ensure that the cables are fully unwound before use.
• Check the pack to make sure you have all of the parts listed.
• Check the set before use for loose or damaged wiring and that all the bulbs are secure. If you are in doubt do not use the set.
• If you are in any doubt about installing this product, consult a qualified electrician.
Siting instructions
• This product is suitable for indoor use only.
• Do not position or place near heaters of any other direct sources of heat.
• Check that all the bulbs are lit. Once checked locate your lights in the desired position.
• This product is not designed for permanent or long term use. Always switch off the light chain overnight or if unattended.
• This product is suitable for positioning on surfaces which have normal flammability, e.g. wood, plasterboard or masonry. However
this does not include highly flammable surfaces (e.g. polystyrene or textiles).
Use instructions
1. Remove all packaging before use and dispose of safely.
2. Using a suitable screwdriver to remove the safety screw and open the battery compartment cover.
Do not lose the screw.
3. Insert 2 x 1.5V AA (LR6) batteries following the proper direction indicated inside the battery compartment. Ensure the battery
polarity signs are followed.
4. Replace the battery compartment cover and the safety screw.
5. Slide the button on the battery compartment and the light set should now be lit.
WARNING:
• This product is for use as a decoration only. Not to be used by children as a toy.
Keep out of reach of small children.
• This product has small parts, which may pose a choking hazard if detached.
• Keep away from fire and sources of heat.
• Do not allow water to come into contact with the batteries or wiring.
• The light source of this luminaire is not replaceable: when the light source reaches
its end of life the whole luminaire shall be replaced. DO NOT attempt to replace
any of the bulbs in the light set.
DING128-06 Silhouette. copper. LED chains GroupDC_NEW3_v3.indd 3
10/05/2019 14:39