Castle, Inc. TSM-12, Руководство пользователя

Страница: 18 / 23

5.2 Web Adjustment
To move the pocket (routed portion) closer to, or further from,
the edge of the material, use a 7/16” wrench and loosen the
Nylock nut next to the operating handle (Fig 29). Moving the
nut away from you will make the pocket cut closer to the edge
of the material, pulling the nut toward you will make the pocket
farther from the edge of the material. Tighten the nut each time
before testing. This is a trial and error method until you get the
Fig 29
pocket where it suits you best.
5.3 Adjusting for Thinner Material
Your TSM-12 is set up for use in ¾” material. It can be adjusted to work in 5/8” or ½” material.
To do so, make a shim the size of the work top from 1/8” or ¼” plywood material. Lay it on the
work table then place your stock on the shim material. Adjust the clamp hold down arm if
necessary and rout through both pieces. When finished processing your thinner material,
remove the shim material and readjust the clamp if necessary. You are again ready for your
regular thickness material.
CASTLE, INC TSM ‐ 12 OWNERS MANUAL V1.0 Page 18 of 23