Step 01:
All units are supplied separate from the back box. The back box must be mounted with
the two cable entries at the top or bottom.
Step 02:
20mm cable entries are provided on all sides and in the base. The back box should be
mounted to a suitable surface or to a standard wiring box, using any of the mounting holes.
Step 03:
The supplied gasket should be used if the surface is uneven or if the unit is to be used
in wet conditions.
Step 04:
To remove the required knockout, the box should be turned on its face. A 6mm screw
driver blade should be placed in the knockout recess and given a sharp tap. The plastic will break
away cleanly.
Step 05:
Connect the power supply to the appropriate terminals (see Salvo Control Panel).
Step 06:
Earth continuity of cable sheath or conduit may be maintained by Þ tting earth tags to the
entry Þ ttings and linking them together inside the back box.
Step 07:
The installation is completed by Þ tting the beacon onto the back box by means of the
supplied screws.
Step 08:
The terminals will accept wires of I4-18AWG. Use the duplicated terminals to route the
in and out wires through the system loop.
Issue 1. April 2008
50
Installation
1
Salvo Traffi c Lights
User Guide
Wiring
2
Refer to SCP wiring schematic diagram on page 29.
