Place the jug on the warming plate, tilt it slightly when you place it.
Plug into outlet, you can hear an acoustic signal, the device is in
standby mode.
Turn the control dial to desired setting (1). You can hear an
acoustic signal, then press start button (2). You can hear another
acoustic signal, the start button is illuminated and flashes, the
device will start to work.
The device will brew coffee until the water tank is empty.
Then you can hear one acoustic signal and the start button is
illuminated without flashing. The device will automatically
enter into keep-warm mode and will switch off automatically
after 30 minutes.
Turn the control dial to Off-position. You can hear an acoustic
signal.
This device is equipped with a drip stop system which
enables you to serve coffee before all the water has dripped
through. Quickly put the jug back in place to avoid any spillage.
Please note
► Use only cold water.
► Do not exceed the maximum amount of water indicated on the scale of water tank.
► For better heat retention, rinse out the jug with hot water before use.
► Wait a few minutes before brewing coffee again.
► The device will keep the coffee warm 30 minutes after brewing and after this
automatically switches off.
4.4 After use
Pull the plug and wait until device is cooled down. Remove the jug from the warming plate.
Remove the grinding/brewing container anticlockwise and lift it upwards. Take out the
filter.
Clean grinding/brewing container, filter, lid of grinding/brewing container and the jug,
please refer to “cleaning and maintenance”.
5 Cleaning and Maintenance
This chapter provides you with important notices with regard to cleaning and maintaining
the device. Please observe the notices to prevent damages due to cleaning the device
incorrectly and to ensure trouble-free operation.
