CASO DESIGN WineDuett Touch 21, Оригинальное руководство по эксплуатации

Страница: 29 / 94

29
First plug in the device and switch it on, then put beverages into the device.
Please note
► Only remove the blue protective film shortly before setting up the device in the location
where it will be used, to prevent scratches and dirt accumulations.
13.4 Disposal of the packaging
The packaging protects the device against damages during transit. The packaging materials
are selected in accordance with environmentally compatible and recycling-related points of
view and can therefore be recycled.
Returning the packaging back to the material loop saves raw materials and
reduces the quantities of accumulated waste. Take any packaging materials that
are no longer required to “Green Dot” recycling collection points for disposal.
Please note
► If possible, keep the original packaging for the device for the duration of the guarantee
period of the device, in order that the device can be re-packaged properly in the event of
a guarantee claim.
13.5 Setup
13.5.1 Setup location requirements:
In order to ensure the safe and trouble-free operation of the device, the setup location must
fulfil the following prerequisites:

Place your appliance on a floor that is strong enough to support the appliance when it is
fully loaded.

Locate the appliance away from direct sunlight and sources of heat (stove, heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.

Ambient temperature below 16°C or above 32°C will hinder the performance of the
appliance.

This unit is not designed for use in a garage or any other outside installation.

Do not set up the device in a hot, wet or extremely damp environment or near flammable
material.

The device requires an adequate flow of air in order to operate correctly. Leave a
clearance of 10-15 cm around the appliance.

Do not cover up any openings on the device and do not block these off.

The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.

The installation and assembly of this device in non-stationary setup locations (e.g. on
ships) must be carried out by specialist companies / electricians, provided they guarantee
the prerequisites for the safe use of this device.