Caslon Rollataq, Руководство по эксплуатации и обслуживанию

Страница: 8 / 8

Page 7
Maintenance
When you have finished coating, replace the black vinyl cover
over the machine to reduce the thickening of the adhesive in
the tray.
Over a period of time (3-7 days depending on humidity and the
quantity of adhesive in the machine) the adhesive in the tray
will start to thicken. If this happens, thin the adhesive by
adding some fresh adhesive into the tray.
If the adhesive gets very thick, then it should be removed and
the machine cleaned.
Remove the screws on both ends of the coater.
Holding the top roller, swivel the coating roller up and out of
the tray.
There are two support plates attached to the back arm which
have a V groove in them. Hook the V groove to the steel base,
to keep the assembly up.
Leave the roller in the up position allowing the adhesive to
drip from the roller.
Lift the roller up, remove the tray and
clean it. Lower the roller down and run paper through the
machine to remove any excess adhesive. You do not have to
clean it perfectly as any adhesive on the roller will dissolve
when the roller runs in fresh adhesive.
If you are not going to use the machine for an extended
period of time you can cover the adhesive tray with the spare
tray supplied. This will keep the adhesive fresh for up to two
weeks. (note: stackable plastic trays in 24” model only, not
36”)