E-31
Normal Operation after Getting Ready
After you finish the procedure under “Getting Ready” (page E-11), you will be able to use the projector
system (Control Box plus one or two projectors) as if it were a single projector. Perform the procedures in
this section using the Control Box remote controller.
To turn on Projector System power
Press the [ALL] key. This will turn the Control Box, Projector A, and Projector B power.
If you are using a configuration that has multiple Control Boxes, press the numbered power key ([1]
through [4]
*
) assigned to the Control Box you want to turn on.
*
For more information, see “To configure initial Control Box settings” (page E-14) and “Control Box
Power On/Off” (page E-14).
To change the input source
When both HDMI input and RGB (or component) input sources are connected to the Control Box, you
can use the remote controller [INPUT] key to toggle between them. Follow the instructions on the dialog
box that appears when you press the key.
To turn off Projector System power
Press twice the [ALL] key or the numbered power key ([1] through [4]) assigned to the Control Box you
want to turn off.
NOTE
z
For full details about using your Projector System, see the “YA-S10 User’s Guide”.
