— 7 —
Pull both ends of the band to tighten it.
•
The band can be adjusted to a circumference from 12cm to 21cm.
Push the band so it raises up in the center of band ring A, and
extend the length of the band.
TO FASTEN THE BAND ON YOUR WRIST
TO ADJUST THE LENGTH OF THE BAND
Extend.
EL Backlight
Pressing the
X
button in the Timekeeping Mode or Alarm Mode
illuminates the display for about three seconds.
•
The display does not illuminate while any number is flashing dur-
ing input operations.
•
The EL (electro-luminescent) panel used to illuminate the display
of this watch tends to lose its brightness after long hours of use.
•
Frequent use of the backlight shortens battery life.
Important!
•
Backlight illumination may be difficult to see under bright sunlight.
•
The backlight automatically turns off if an alarm starts to sound
while it is lit.
1
Pass the band through the bottom hole in the buckle (see fig-
ure).
2
Double the band back through the loop of the buckle and pull it
tight.
1 2
Slide band ring A into position and pass the free end of the
band through it.
3
Push up.
Ring A
