— 13 —
3. How to use ADJ Tool when replacing MAIN PCB
Firmware is not installed in spare parts.
1
Enter the TEST mode.
1. Turn the power on while pressing both "BS" and "UP" buttons.
2. Press "DOWN" button, "DOWN" button, "BS" button and "MENU"
button while the program version is displayed.
3. Select "2.USB TCC TEST", and press "SET" button.
4. Select "1. USB TCC ON", and press "RIGHT" button, "RIGHT"
button and "SET" button.
5. Turn the power OFF.
2
Connect the camera to the PC by the USB cable.
3
Boot "AdjUSB".
4
Select the model name and click "Load FW
" Key.
• Kx847 EX-Z1050
5
Click "ADJ ALL READ", and display the data on the "AdjUSB".
6
Save the data.
7
Replace the MAIN PCB.
8
Writing the Firmware.
Write the firmware into a spare part after replacing one.
NOTE: If a battery is inserted without the firmware, only LED
blinks green and the camera does not operate.
9
Perform the above
1
to
3
.
0
Select the model name and click "Load FW
" Key.
• Kx847 EX-Z1050
A
Open the file which is saved above, and display the data on the
"AdjUSB".
B
Click "WRITE" button of "ADJ ALL".
C
After adjustment, change "1. USB TCC ON" to "2. USB TCC OFF".
6
4
5
A
B
