22
Quick Start Basics
To replace the battery
1.
Press [ON/OFF] (Power) to
turn off the camera and then
open the battery cover.
2.
Remove the current battery
and load a new one.
3.
Close the battery cover.
IMPORTANT!
• The back lamp (page 11) will flash green for some time after you press [ON/OFF]
(Power) to turn off the camera. Never remove the battery while the back lamp is
flashing green. Doing so can result in corruption or loss of data in camera memory.
You can use either of the two following methods to charge the camera’s battery.
• USB-AC adaptor (page 22)
• USB connection to a computer (Using the included micro USB cable.) (page 24)
.
To charge with the USB-AC adaptor
The adaptor lets you charge the battery while it is loaded in the camera.
While the camera is turned off, connect in the sequence shown below.
Charging time: Approximately 240 minutes
• When disconnecting the USB-AC adaptor from the camera, be sure to disconnect
from the camera first.
Charge the Battery
Stopper
4
3
2
1
USB-AC adaptor
(AD-C53U)
u
mark of the small (micro USB) connector
facing the monitor screen side of the camera.
[USB] port
Power cord
Micro USB cable
(included with camera)