Casio EX-Z4 - EXILIM Digital Camera, Руководство по обслуживанию и список запасных частей, Страница: 9 / 35

— 7 —
■
Introduction
Update the program using an SD card.
Note:
Make sure to use a fully charged battery.
MAIN PCB becomes unusable if power down or an error occurs during program transmission.
1. How to confirm the program version
■
The program version can be confirmed in the test menu (refer to the previous page).
■
Turn the power on while pressing MENU button.
The following program version can be found.
Check the LCD display.
(Example)
2. How to update the firmware
1. Prepare the memory card which contains the software for upgrading EX-Z4 firmware in the root directory.
firmware: EX-Z4.bin
The firmware is included in the service CD-ROM.
The location is as follows: QV/Soft/Adj-soft/Exz4/FirmUP
2. Insert the above memory card in the camera and then set a fully charged battery in the camera.
3. While pressing MENU, press power switch. Keep pressing MENU until “PROGRAM UPDATE” appears
in the camera LCD.
• The following appears.
• The version for the firmware update software in the memory card appears at the bottom.
Note:
This does not appear when the battery is low.
Make sure to charge the battery fully.
4. Align the white cursor to “YES” by the cross key of
왖
and
왔
, and press SET of the center of the cross
key.
• “NOW LOADING” appears in the LCD and the update starts.
5. “COMPLETE” appears after the update finishes.
VER 1.00
PROGRAM VERSION UPGRADING
PROGRAM UPDATE
YES
NO
NEW VERSION IS
VER 1.00
(As of September 19. 2003)