Deleting All Records
1.
Enter the Data Recall Mode.
l
2.
Hold down (A) for at least five seconds.
When [CLR] stops flashing, it means that
the data of the date and time you specified
has been deleted. If you keep the button
depressed, [ALLCLR] will flash for about
1.5 seconds and then stop, which
indicates that all data was deleted.
Note
●
You cannot delete data while an
elapsed time measurement operation
is in progress.
Timer
The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
Setting the Countdown Start
Time
The start time can be set in 1-second units up
to 100 minutes.
●
If a timer operation is in progress, press (D)
to stop it and then press (B) to reset the
stopwatch to all zeros before performing the
operation in step 2.
1.
Enter the Timer Mode.
l
2.
Hold down (A) for at least two seconds.
Release the button when the minutes
setting starts to flash.
●
This enters the setting mode. The
hands automatically shift out of the way
for easy viewing of the screen.
Minutes
3.
Use (B) and (D) to change the minutes
setting.
●
Holding down (B) or (D) scrolls through
settings at high speed.
4.
Press (C).
This causes the seconds digits to flash.
Seconds
5.
Use (B) and (D) to change the seconds
setting.
6.
Press (A) to complete the setting
operation.
Note
●
Setting a start time of [00’00] will
perform a countdown of 100 minutes.
●
While the setting is being configured,
the watch will exit the setting operation
automatically after about two or three
minutes of non-operation.
Using the Timer
1.
Enter the Timer Mode.
l
Seconds
Minutes
2.
Use the operations below to perform a
timer operation.
D
D
D
(Time up)
Resume
Pause
(Countdown starts)
Start
●
A beeper will sound for 10 seconds to
let you know when the end of a
countdown is reached.
●
You can reset a paused countdown to
its start time, by pressing (B).
3.
Press any button to stop the tone.
Watch Operation Guide 5692
15