Casio 3459, Руководство по эксплуатации, Страница: 11 / 22

World Time City Setting
You can specify up to five cities as your World
Time favorites. If you are in an area that
observes summer time, you can also enable
or disable summer time.
Note
●
The initial factory default summer
time setting for all cities is “AUTO”.
In many cases, the “AUTO” setting
lets you use the watch without
switching between summer time and
standard time.
1.
Use (D) to display the World Time number
whose setting you want to configure.
2.
Hold down (A) for about two seconds.
This causes [WT] to flash on the display.
3.
Use (D) and (B) to display the city you want
to assign to the World Time number.
4.
If you want to change the summer time
setting, press (C).
5.
Use (D) to select a summer time setting.
Each press of (D) cycles through available
settings in the sequence shown below.
●
[AUTO]
The watch switches between standard
time and summer time automatically.
●
[OFF]
The watch always indicates standard
time.
●
[ON]
The watch always indicates summer
time.
6.
Press (A) to exit the setting screen.
Note
●
While [UTC] is selected as the city,
you will not be able to change or
check the summer time setting.
Swapping Your Home City
Time and World Time
Press (A) and (B) at the same time to swap
your Home City time and World City time.
After swapping Before swapping
World Time
World Time
Home Time
Home Time
Note
●
This function comes in handy when
you need to move to another time
zone. For details about how to use it,
go to the section below.
l
Moving to Another Time Zone
Alarms and Hourly Time
Signal
The watch will beep when the alarm time is
reached. You can configure up to four
standard daily alarms, and one daily alarm
with snooze. The hourly time signal causes the
watch to beep every hour on the hour.
●
Snooze causes the alarm to sound up to
seven times, at five-minute intervals.
●
The alarm sound is muted in the cases
described below.
—
When battery power is low
—
When watch is at Level 2 power saving
l
Power Saving Function
Getting ready
Enter the Alarm Mode.
l
Navigating Between Modes
Configuring Alarm Settings
1.
Use (D) to display the alarm screen (alarm
number [1] to [4] or [SNZ]) whose setting
you want to change.
Alarm time
Alarm number
2.
Hold down (A) for about two seconds.
This causes the hour digits to flash.
Hours
3.
Use (D) and (B) to change the hour setting.
●
If you are using 12-hour timekeeping,
[P] indicates p.m.
4.
Press (C).
This causes the minute digits to flash.
Minutes
5.
Use (D) and (B) to change the minute
setting.
6.
Press (A) to exit the setting screen.
7.
Press (C) three times to return to the
Timekeeping Mode.
Operation Guide 3459
11