Operation Guide 3277/3404
L-1
City Code Table
E-38
Stopwatch
Measuring unit: 1/100 second
Measuring capacity: 23:59' 59.99"
Measuring modes: Elapsed time, split time, two fi nishes
Illumination:
EL (electro-luminescent panel); Selectable illumination duration
Other:
Button operation tone on/off, Flash Alert
Battery:
One lithium battery (Type: CR2016)
Approximately 5 years on type CR2016 (10 seconds of alarm operation per day
(with Flash Alert), one countdown timer operation (with progress beeper and Flash
Alert) per week, one stopwatch operation (with auto start and Flash Alert) per week,
1.5 seconds of illumination per day)
E-37
Specifi cations
Accuracy at normal temperature:
±
30 seconds a month
Timekeeping:
Hour, minutes, seconds, p.m. (P), month, day, day of the week
Time format: 12-hour and 24-hour
Calendar system: Full Auto-calendar pre-programmed from the year 2000 to 2099
Other: UTC Offset; Daylight Saving Time (summer time)/Standard Time
World Time:
48 cities (29 time zones)
Other: Daylight Saving Time/Standard Time
Alarms:
3 multi-function* alarms (two one-time alarms; one snooze alarm);
Hourly Time Signal
* Alarm type: Daily alarm, date alarm, 1-month alarm, monthly alarm
Countdown Timer
Measuring unit: 1 second
Input range: 1 minute to 24 hours (1-minute increments and 1-hour increments)
Other: Auto-repeat timing; Progress beeper
E-36
The letters “UTC” is the abbreviation for “Coordinated Universal Time”, which is the
x
world-wide scientifi c standard of timekeeping. It is based upon carefully maintained
atomic (cesium) clocks that keep time accurately to within microseconds. Leap
seconds are added or subtracted as necessary to keep UTC in sync with the Earth’s
rotation.
Illumination Precautions
Illumination may be hard to see when viewed under direct sunlight.
x
Illumination turns off automatically whenever an alarm sounds.
x
Frequent use of illumination runs down the battery.
x
E-35
Timekeeping
Resetting the seconds to
x
while the current count is in the range of 30 to 59
causes the minutes to be increased by 1. In the range of 00 to 29, the seconds are
reset to
without changing the minutes.
The year can be set in the range of 2000 to 2099.
x
The watch’s built-in full automatic calendar makes allowances for different month
x
lengths and leap years. Once you set the date, there should be no reason to change
it except after you have the watch’s battery replaced.
World Time
All World Time Mode times are calculated from the current time in the Timekeeping
Mode using UTC offset values.
The seconds count of the World Time is synchronized with the seconds count of the
x
Timekeeping Mode.
The UTC offset is a value that indicates the time difference between a reference
x
point in Greenwich, England and the time zone where a city is located.
E-34
Auto Return Features
If you leave the watch in the Alarm Mode for two or three minutes without performing
x
any operation, it automatically changes to the Timekeeping Mode.
If you leave a screen with fl ashing digits on the display for two or three minutes
x
without performing any operation, the watch automatically exits the setting screen.
Scrolling
The
B
and
D
buttons are used in various modes and setting screens to scroll
through data on the display. In most cases, holding down these buttons during a scroll
operation scrolls at high speed.
Initial Screens
When you enter the World Time or Alarm Mode, the data you were viewing when you
last exited the mode appears fi rst.
E-33
Button Operation Tone
The button operation tone sounds any time you press one
of the watch’s buttons. You can turn the button operation
tone on or off as desired.
Even if you turn off the button operation tone, the alarms,
x
the Hourly Time Signal, the countdown alarm, and
stopwatch auto start all operate normally.
To turn the button operation tone on and off
In any mode (except when a setting screen is on the display), hold down
C
to toggle
the button operation tone on ( not displayed) and off ( displayed).
Holding down
x
C
to turn the button operation tone on or off also causes the watch’s
current mode to change.
The
x
indicator is displayed in all modes when the button operation tone is turned
off.
E-32
Flash Alert
When Flash Alert is turned on, the illumination fl ashes for
the alarms, the Hourly Time Signal, the countdown alarm,
and stopwatch auto start.
To turn Flash Alert on and off
In the Timekeeping Mode, hold down
1.
A
until the
seconds start to fl ash, which indicates the setting
screen.
Press
2.
C
eight times to display the Flash Alert setting screen.
Press
3.
D
to toggle Flash Alert on (
displayed) and off (
displayed).
Press
4.
A
to exit the setting screen.
The Flash Alert setting you select with the above procedure is applied in all modes.
x
When Flash Alert is on,
x
appears on the timekeeping screen for about one
second whenever you enter the Stopwatch, Countdown Timer, or Alarm Mode.
E-31
Reference
This section contains more detailed and technical information about watch operation.
It also contains important precautions and notes about the various features and
functions of this watch.
Graphic Area
The information shown in the graphic area depends on the current mode.
Mode
Graphic Area
Timekeeping
Timekeeping Mode seconds
World Time
Timekeeping Mode seconds
Stopwatch
Stopwatch time seconds
Countdown Timer
Countdown time seconds
Alarm
No indication
Graphic area
E-30
Illumination
This watch has an EL (electro-luminescent) panel that causes the entire display to
glow for easy reading in the dark.
To illuminate the display
In any mode, press
B
to turn on illumination.
You can use the procedure below to select either 1.5 seconds or 3 seconds as the
x
illumination duration. When you press
B
, the illumination will remain on for about
1.5 seconds or 3 seconds, depending on the current illumination duration setting.
To specify the illumination duration
In the Timekeeping Mode, hold down
1.
A
until the
seconds start to fl ash, which indicates the setting
screen.
While the seconds are fl ashing, press
2.
B
to toggle the
setting between 1.5 seconds ( ) and 3 seconds ( ).
Press
3.
A
to exit the setting screen.
