WX210 - WX240
SAFETY INSTRUCTIONS
0 - 27
Dismantling components
After repair work
Never dismantle while the machine
is still at operating temperature.
Oils, greases, brake fluid or coolant
may have a high temperature and
thus result in burning or scalding.
Wait for the machine to cool down.
Depressurize pipelines and hoses,
cylinders, radiator, hydraulic tank,
compressed air reservoir and other
systems or units before starting
work.
Replace defective components in
good time to prevent greater dam-
age.
Clean the defective component
carefully before dismantling it.
Mark dismantled components in the
correct sequence to facilitate instal-
lation.
When dismantling the component,
close exposed hose and pipe con-
nections, open boreholes and hous-
ings with care to prevent dirt from
penetrating.
To prevent corrosion, coat all bright
metal machine components with a
grease film.
On completing the work, reassem-
ble all protective devices, covers,
and sound- and vibration-insulation
material.
Never start up the driving motor
while work is being done on the ma-
chine.
Check the repaired components and
all machine functions with a trial run.
Never release the machine for re-
commissioning until it is fully func-
tioning.
Correct waste disposal
Incorrectly discarded waste is an
environmental hazard. Hazardous
substances used in excavators in-
clude lubricants, fuels, coolants,
brake fluids, filters and batteries.
-
Use sealed containers to discard
fluids. Never use containers de-
signed for food or drinks.
-
Never discard waste onto the
ground, into drains or into water.
Ask your local authorities, collec-
tion points or dealer about the cor-
rect procedure for recycling or dis-
carding waste.
Î
Carefully read personal and machine SAFETY INSTRUCTIONS (at the beginning of this manual)
