2000-12
STEP 30
Position a trolley jack under the transmission, next to
the front axle drive coupling flange. Raise the jack
into contact with the transmission but DO NOT lift the
transmission.
STEP 31
Attach the special lifting bracket to the engine.
STEP 32
789M256A
Using a suitable hoist attached to the lifting bracket,
apply tension to the lift chains. DO NOT raise the
engine.
STEP 33
789M257A
Loosen the two bolts (62) and the nuts (60) from each
engine bracket (61).
STEP 34
789M276A
Remove the centre bolt (67), the nuts (64) and the
washers (63) and (66) from each transmission
mounting plate (65).
STEP 35
Remove the rear propshaft.
STEP 36
Using the hoist and trolley jack, raise the engine/
transmission unit sufficient to remove the engine
mountings. (approximately 40 mm (1.5 in)).
STEP 37
Lower the engine/transmission unit and move it
towards the rear of the machine until the rear prop-
shaft slicing joint is completely closed.
STEP 38
Remove the two bolts in the spacer housing.
Cre 7-21290GB
Issued 10-99
6
60
0
6
6
2
2
6
6
1
1
6
6
7
7
6
6
6
6
6
6
5
5
6
63
3
6
6
4
4