Case 595LSP, Руководство по обслуживанию

Страница: 21 / 22

2000-4
Cre 7-21290GB Issued 10-99
RADIATOR REMOVAL
Put identification tags on all disconnected hoses and
wires. Close disconnected hoses and fittings with
caps and plugs.
STEP 1
Park the machine on a level surface. Raise the loader
and install the support strut to hold the loader.
STEP 2
Open the hood.
STEP 3
Remove the bolts, washers, and nuts from the pivot
point on the hood.
STEP 4
Have another person help with the following proce-
dure :
A. Remove the retainers from the hood struts and
disconnect the hood struts from the stud.
B. Remove the hood from the machine.
STEP 5
Slowly remove the radiator cap.
NOTE : During installation, fill the radiator and cool-
ant reservoir completely. See Section 1002 for cool-
ant specifications. Start and run the engine until the
coolant is at operating temperature. Stop the engine
and check for leakage. When the coolant is cold,
check the coolant reservoir level. Add coolant as
required. Never remove the radiator cap to check the
coolant level in the radiator.
STEP 6
Depressurize the hydraulic system as follows see
section 8002.
STEP 7
Disconnect the hoses from the hydraulic filter.
STEP 8
Remove and fit blaks to the expansion reservoir
hoses.
WARNING : Do not remove the cap when the
engine is hot. The circuit is still under pressure
and you could be scalded.
!
STEP 9
Tag and disconnect the wires on the audible warning
device.
STEP 10
Tag and disconnect the wires on the hydraulic filter
obstruction indicator.
STEP 11
789M250A
Release the fluid pipes (1) and electrical connections
(2) to the screen wash bottle (3) and tie back to the
chassis.
3
2
1
3
2
1