INTRODUCTION
Reassembling hydraulic equipment
• Clean parts in a well ventilated room.
• Remove residual oil with compressed air, and apply fresh hydraulic oil or gear oil to surfaces before reassembly.
• Replace removed o-rings, back-up rings and oil seals with new ones. Apply gear oil on them before reassembling.
• Thoroughly clean and dry surfaces on which liquid sealant must be reapplied.
• Before assembling, remove rust preventives on new parts.
• Use special tools to fit bearings, bushing and oil seal.
• Assemble parts matching to the marks.
• After completion, check that there is no omission of parts.
48082189_EN 14/02/2017
17