8
PRE-OPERATION SAFETY
1.
This unit should only be placed on a level surface to ensure proper lubrication for the
water pump while operating. Placing the unit on a level surface will also ensure that
fuel, oil, and other fluids don’t spill during operation. NEVER spray water directly on
the unit.
2.
Do not use unit in an area:
a. with insufficient ventilation.
b. where there is evidence of oil or fuel leaks.
c. where flammable gas vapors may be present.
This unit has multiple ignition sources that could cause a fire or explosion.
3.
If using a wheel kit, be certain to block the wheels to prevent the unit from moving
while operating.
4.
Do not allow the unit to be exposed to rain, snow, or freezing temperatures. If any
part of the unit becomes frozen, excessive pressure may build up in the unit which
could cause it to burst. This would result in possible serious injury to the operator or
bystanders.
5.
Pump oil level should be checked before each use. Make certain the oil is on the “Full”
mark on the dipstick or in the center of the oil sight glass. If the level appears to be
low, fill with SAE30W non-detergent pump oil.
6.
Your pressure washer is equipped with an Electric Starter. On initial start-up, wear
proper eye and skin protection when filling the battery with acid. Fully charge the
battery to allow Electric Starter to function.
BEFORE STARTING THE UNIT
1.
Review “Risk of Explosion or Fire” warnings, before fueling.
2.
Locate the Safety Decals on your unit and heed their warnings.
3.
Engines: See the included engine Owner’s Manual for fuel requirements.
Burner Fuel: When filling tank, use No. 1 or No 2 fuel oil/diesel or kerosene.
4.
Check the engine oil level before starting the engine.
5.
Review the Engine Manual accompanying this pressure washer for correct engine
start-up and maintenance procedures.
MANUAL & SAFETY REVIEW
PRE-START INSPECTION PROCEDURES
Before starting the unit, perform the following procedures:
1.
Check the oil level and condition for the pump and engine. We recommend
SAE
10W30
oil for engines and
SAE 30
mineral oil for pumps.
2.
Inspect the water inlet strainer. Clean or replace if necessary.
3.
Check all hose connections to ensure they are securely tightened.
4.
Inspect for system water leaks, oil leaks and fuel leaks.
If a fuel leak is found, do not
start the unit.
See “Risk of Explosion or Fire”, pg. 6. Be sure that all damaged parts
are replaced and mechanical problems are corrected prior to operation of the unit.
5.
Inspect high pressure hoses for kinking, cuts, and leaks.
If a cut or leak is found, do
not use the hose.
Replace hose before starting unit. See “Risk of Injection” pg. 5.
Be sure that all damaged parts are replaced and that the mechanical problems are
corrected prior to operation of the unit.
