3
CV072018-1
CEPHIRUS-2
SECURITY AND MARKING STANDARDS “CE”
Our R & D department is concerned with achieving efficient products in compliance with the current “safety standards”. The rules and
recommendations set out below mainly reflect what is in effect in safety material and therefore are mainly based on compliance with the
general rules. Therefore, we strongly recommend all the people who manipulate the machine to follow the rules of accident prevention in
their place and in their country. Casals ventilation is exempt from any liability for any damage caused to people or property arising from
non-compliance with safety regulations, as well as any changes made to the product.
The CE marking and the relative declaration of conformity certify compliance with applicable Community standards. Products that are not
marked on the CE plate must be completed by the buyer who must then certify the entire plant, thus providing the certificate of conformity.
The machines meet the requirements of:
- Machinery Directive 2006/42 / CE.
- Low voltage directive 2014/35 / CE.
- With the Electromagnetic Compatibility Directive 2014/30 / CE.
- Ecodesign Directive 2009/125 / CE.
GENERAL RULES
Safety guards should not be removed if it is not due to absolute need for work; in which case appropriate measures must be taken that
must be taken immediately in the event of possible danger.
All maintenance work (ordinary and extraordinary) must be carried out with the machine stopped, electrical power, pneumatic etc ... dis-
connected. To avoid the danger of accidental insertion, stick on electrical panels, control units and control consoles
warning signs with the words “Warning: command excluded for maintenance in progress”. Before connecting the power cable to the termi-
nal board verify that the line voltage is suitable for that shown on the machine’s plate, pay attention to the labels placed on the product; if
time goes by they should become illegible and they would have to be replaced.
The device must not be used by people (including children) whose physical, sensory or mental abilities are reduced, or with lack of expe-
rience or knowledge, unless they have been able to benefit, through the intermediation of a responsible person in their security, surveillan-
ce or instructions on the use of the device. Children should be checked to prevent them from playing with the device.
MAINTENANCE
The maintenance staff, in addition to having to observe the current legal provisions on accident prevention, must comply with the instruc-
tions shown below:
- Wear appropriate safety clothing.
- Use soundproof headphones when the noise exceeds the allowed limit.
- Verify the existence of an interlock that foresees the start-up of the machine by other people.
These heat recovery systems lack the maintenance periodically to perform correctly the function for which they were designed. The fre-
quency with which maintenance is performed depends on the characteristics of the environment in which the device is inserted and the
number of hours of operation, so what is indicated below should be seen as guidance.
Fan
Operations to be carried out:
• Check if there are no foreign bodies inside the module.
• Check that all screws are tightened to avoid unwanted vibrations.
• General interior cleaning.
Maintenance interval: half-yearly
Filters
Operations to be carried out:
• Check if there are no foreign bodies inside the module.
• Check that all screws are tightened to avoid unwanted vibrations.
• Check if there are no cuts in the filter mat.
• Check the clogging status of the filters (clean or replace if necessary).
• General interior cleaning.
Maintenance frequency: monthly
