26
system is connected to the internet. If it is in white, please re-boot the monitor and
home router, then wait for 15 minutes to get the green icon.
A brief introduction to the network status indicator on the monitor:
Red - monitor is not connected to router. Check the RJ45 cable connection.
White - monitor is connected to router, but router is not connecting to internet. You
may need to reboot your router as well as the 7" monitor.
Green - monitor is connected to router and the internet, and ready for remote
access.
12.4 Out of Range
Reboot the monitor to get wireless signal reconnected.
Make sure the camera is connecting with the power adapter.
Make sure the camera is paired with the monitor.
Tighten the camera’s antenna (screw the antenna in tightly, and allow the
antenna pointing to the sky.) Pull up the antennas on the monitor.
If still out of range, you can purchase a repeater or antenna extension cable
(not included, sold separately), or repeater (not included, sold separately) to
extend the range.
13.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
To assure continued compliance, any changes or modifications not expressly
approved by the party.
Responsible for compliance could void the user’s authority to operate this
equipment. (Example- use only shielded interface cables when connecting to
computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules. Operation is subject to
