7
L
a
F
Leur
™
Prepare for fan installation as follows:
Step 5a.
Remove the paper shield from the motor.
Step 5b.
Secure the motor adapter cover plate with the three
provided screws.
Step 5c.
Route the wires through the motor adapter cover
and downrod.
Tip: The downrod has a tapered thread that is designed to
lock completely when installed correctly.
Step 5d.
Using the provided Allen wrench (attached to the
paper motor warning shield), remove the Allen set screw
from the hanger adapter and set it aside. Insert the downrod
into the motor coupling and turn it clockwise until it stops
turning, ensuring that the pole has bottomed out.
Step 5e.
While holding the adapter motor cover securely,
insert the set screw and tighten it with the provided Allen
wrench to ensure safe operation of your fan. If it is tight
enough, you should not be able to turn the downrod
counterclockwise with your hands. If in doubt, tighten the
set screw with the Allen wrench until you cannot turn it any
further.
CAUTION: Failure to fully lock in the downrod
before securely tightening the Allen set screw may
cause the fan to separate from the downrod and fall
during normal operation.
IMPORTANT SAFETY INFORMATION:
Before starting the installation of your ceiling fan,
install the threaded downrod into the motor coupling
and lock the assembly
FAN PREPARATION
Motor
Coupling
Motor Wires
(leave at least 6
”
long)
Ground Wire
Allen
Set Screw
Perma•Lock™ Downrod
and Ball Assembly
Motor Adapter
Cover
Tapered
Thread
Motor Adapter
Cover Plate
Allen Set Screw
1
⁄
4
-20 X
1
⁄
4
”
(pre-installed)
Allen Wrench
Perma•Lock™ Downrod and
Ball Assembly
Motor Adapter Cover
Perma•Lock™ Hardware
(not to scale)
Motor Adapter
Cover Plate
Motor Housing
Assembly
Motor Adapter Cover
Plate Screw
Motor Adapter
Cover Plate Screw
