IMPORTANT SAFETY INSTRUCTIONS
22.
Before connecting a new product to your audio or home theater system, turn off all other equipment (preferably unplugging
them from the AC power source). Many audio components feature automatic turn-on circuits that may activate during an
installation, potentially causing damage to electronic components and/or speakers. This type of damage is not covered by
product warranties, and Cary Audio specifically disclaims responsibility for any
such damage.
23.
The removable power cord provided with your unit was specifically designed for use with this product,
but other AC cords may be used. Consult your dealer for advice on AC power cords and high quality wire
in your system.
24.
The fuse is located inside the chassis and is not user serviceable. If the unit does not power up, contact an authorized service
representative
25.
Cables running inside walls should have the appropriate markings to indicate compliance and listing by the UL, CSA or other
standards required by the UL, CSA, NEC or your local building code. Questions about cables inside of walls should be
referred to a qualified custom installer, a licensed electrician, or low-voltage contractor.
26.
Recording of copyrighted material for other than personal use is illegal without permission of the copyright holder.
CAUTION:
High current. Connect to earth before connecting to supply of unit. Unplug the
unit before performing any service.
Unit can be hot. Be careful of burned fingers when handling parts.
Wait one half hour after switching off to handle parts.
NOTE TO CATV SYSTEM INSTALLER:
This reminder is provided to call the CATV system installer's attention to article 820-
40 of the NEC, ANSI/NFPA 70, which provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.
FCC INFORMATION FOR USER:
•
CAUTION:
Any changes or modifications not expressly approved by Cary Audio
Design could void the user's authority to operate the equipment.
•
NOTE:
This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to Part 15 of the FCC Rules.
•
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates and can radiate radio frequency energy, and if not installed and used in accordance
with the instructions it may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Connect the equipment into an outlet on a circuit different from where the receiver is connected.
OUTDOOR ANTENNA INSTALLATION/SAFE ANTENNA AND CABLE CONNECTION:
•
If an outside antenna or cable system is connected to the
equipment, be sure the antenna or cable system is grounded in
order to provide protection against built-up static charges and
voltage surges. Article 810 of the National Electrical Code,
ANSI/NFPA 70 (in Canada, Part 1 of the Canadian Electrical Code)
provides information regarding proper grounding of the mast and
supporting structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location of antenna
discharge unit, connection to grounding electrodes and
requirements for the grounding electrode.
•
Outside antenna system should be located well away from power
lines, electric light or power circuits and where it will never come
into contact with these power sources if it should happen to fall.
When installing an outside antenna, extreme care should be taken
to avoid touching power lines, circuits or other power sources as
this could be fatal. Because of the hazards involved, antenna
installation should be left to a professional.
3