Specifications
10
Operating the CDP 1 CD player is a simple procedure, since each unit is designed for long term
stability in virtually any home operating situation. However, if the unit is operated outside the
parameters outline in this owner's manual, damage may result. Please read this manual carefully
before putting your new Cary Audio Design CDP 1 in operation.
1.1 Specifications
The following section describes the CDP 1 CD player basic specifications.
Specifications are subject to change without notice or obligation.
CD Mechanism
Triple-beam laser, multi speed CD/DVD ROM transport
Formats
CD AUDIO (CD-DA), CD-R, CD-RW
Master Clock Jitter
Digital Filter
Digital / Analog Converters
Analog Filter
Analog Outputs
Digital Output
Frequency Range
Amplitude Linearity
Frequency Response
Signal-to-Noise Ratio
Balanced
Trigger Input
Power Input
Power Consumption
Below measurable levels
CARY DSP 300 with HDCD decoding
Two (2) Burr Brown PCM 1792u
3
Order Bessel
Balanced XLR, Single - Ended RCA
Coaxial, Toslink operating at Sample Frequency (FS)
from 44.1 kHz / 16 bit to 192 kHz / 24 bit
2 Hz - 22 kHz (44.1 kHz)
0.1 dB (20 Hz-20 kHz)
12.0 V DC
Configured at the factory for either
110-117 or 220-234 V AC, 50-60 Hz
50 Watts
rd
Phase Linearity
3 (20 Hz - 20 kHz)
O
129 dB (1 kHz)
122 dB (1 kHz)
Channel Separation
104 dB (1kHz)
Total Harmonic Distortion
0.003 % (1 kHz)
Audio Output level
3.0 V RMS (220
output impedance)
+3.0 V RMS (440
output impedance)
-
IR Input
PHILIPS RC 5 IR code
Comms.
RS 232 full remote configuration interface
