Cary Audio Design CAD-1610-SE, Руководство по эксплуатации

Страница: 6 / 14

The operation of the CAD-1610-SE mono block amplifier is a simple procedure since each unit is
designed for long term stability in virtually any home operating situation. Therefore, if the unit is
operated outside the parameters outlined in the Operating Manual, damage may result. Please read
the Operating Manual carefully before operating the CAD-1610-SE amplifier.
CAUTION TERMS
When the following cautionary terms are used in this manual, these definitions apply:
WARNING: Electrical hazard! Misuse or failure to follow instructions properly
may result in personal injury or death!
CAUTION: No risk or personal injury; however, misuse or failure to follow
instructions may result in damage to equipment.
NOTE: No risk of personal injury or equipment damage; however, misuse
or failure to follow instructions may prevent proper performance
to the equipment.
SPECIFICATIONS
This section describes the basic specifications of the CAD-1610-SE at the time of printing.
Specifications are subject to change without notice or obligation.
WEIGHT : 130 lbs.
DIMENSIONS : 22-1/2”H x 13-1/2”W x 18-1/2”D
CIRCUIT TYPE : Class A Single-Ended, Shunt Feed
POWER OUTPUT : 55 watts RMS (Steady State Continuous)
: 100 watts PEP (Peak Envelope Power)
INPUT SENSITIVITY : 2 Volt for Full Output
NOISE AND HUM : -85 dB below Full Output
FREQUENCY RESPONSE : 15 Hz-23khz +/- .75 dB
POWER TRANSFORMER : 200% Duty Cycle EI Laminate - 8 separate
supplies