FEATURES DESCRIPTION
2.Never start the vehicle if it is not in either PARK or NEUTRAL position and never forget to
activate the parking brake before remote start.
3.In gasoline vehicles, the engine will wait 6 seconds to start after the parking lights flash. In diesel
vehicles, the engine will start when the WAIT-TO-START indicator on the vehicle's dash goes out.
4.It is unsafe to remote start the vehicle in a garage or other enclosed area. Breathing the exhaust
from the vehicle is hazardous to your health.
How to Drive Your Remote Started Vehicle:
1) Press button 0.5s to unlock and disarm and open the door.
2) Insert the ignition key and turn it to the ON (not the START) position in 30 seconds.
3) Press the brake pedal.
Note: If the brake pedal is pressed before the key is in the ON position, the engine will shut down
.
Remote shut down:
While the vehicle is running during remote start operation, the system will monitor the vehicle and will
automatically shut down the engine if the system receives any of the following shut-down inputs:
1)The brake pedal is pressed.
2)The hood is opened.
3)The pre-programmed run time (15 or 25 minutes) has elapsed.
4)Press button and button again.
5)The TACH or Oil sensor or High voltage signal disappear.
Remote Engine Start (Must Need Remote Start Module)
Rolling
Air-conditioner begins
to work for 15 or 25
minutes duration
Horn sound twice
Parking lights flash twice
System returns to disarming state
All alarm are released
Parking
Disarm the System Without Remote Control
Parking
switch
Pin 4: GREY WIRE:
Hood Pin Input (-). Connect this wire to the hood pin switch. The switch must supply a
ground output(-)when switch is opened. This input will disable or shut down the remote start when the hood is
opened. It will also trigger the security system if the hood is opened while the system is armed.
Pin 5: BROWN WIRE:
Brake Input (+). Connect to the wire that shows +12V when pressing the brake. The
brown wire is a safety shutdown wire that must be connected.
Pin 6: YELLOW WIRE:
(+) Ignition Input of the Key Cylinder to Alarm. Connect to the ignition wire that
pr12V when the ignition is on and while cranking the starter.
Pin 7: GREEN WIRE:
Negative Door Input (-). Most vehicles use negative door trigger circuit. Connect the
green wire to the wire that shows ground when any door is opened. In vehicles with factory delays on the dome-
light circuit, there is usually a wire that is unaffected by the delay circuit.
Pin 8: PURPLE WIRE:
Positive Door Input (+). Connect to the door switch circuit wire that shows +12V
when any door is opened. This type of door circuit is usually found on Ford Vehicle.
SYSTEM INSTALLATION
7-PIN White Connector: Two
-way Transceiver Communication Port
3-PIN Black Connector:
Optional Sensor Input port, for example, the Microwave Sensor.
2-PIN White Connector: LED Port.
Mount LED in an area where it may be easily seen from either side
of the vehicle.
Peripheral Plug-in Connectors
Door Lock Wiring Diagram
In arming state
1. The parking lights will flash every 30 seconds during the engine is running
Note:
Содержание CX990
Страница 1: ......
