OWNER’S MANUAL
SYSTEM OPERATING INFORMATION
98
7
3237 • X6 02/2018
Never use a GFCI or any receptacle on a
GFCI circuit if power is still available on that
circuit after the test button has been pressed.
Death or serious injury can occur by receiving
an electrical shock from the AC electrical
system including the Ground Fault Circuit
Interrupter (GFCI) receptacle. Seek immediate
medical attention after receiving an electrical
shock. Contact a qualified electrician to make
appropriate repairs.
DANGER
!
Reset
Test
Figure 7-21
1 ]
Press the TEST button. If operating normally, it cuts
the electricity to the receptacle on the GFCI.
2 ]
Plug a lamp or other AC-powered device into the
receptacle, and turn ON the device. The device
should NOT operate.
3 ]
Press the TEST button. Never use the receptacle
if the receptacle still has power. Contact a qualified
electrician to make the appropriate repairs.
4 ]
Reset the GFCI to restore power to the receptacle.
ELECTRICAL LOADS
Never overload the electrical circuits. Turn off
all devices connected to the circuit, and then
switch the breaker back on if an excessive load
trips a circuit breaker.
WARNING
!
Be aware that each device exerts a “load” on the system
when operating AC-powered devices through the AC
electrical system. The electrical load is equal to the
amount of current (amps) that the device draws from
the AC electrical system. The AC electrical system is
designed with a maximum total load that the device can
handle. Each LINE circuit has an electrical load capacity
of 30 amps.
The MAIN circuit breaker groups on the AC control center
will trip if the total load on the circuit exceeds the circuit’s
capacity; it will trip if the devices operating from the
circuit are drawing too much current. See
shows common AC-powered devices and
the approximate maximum current that the devices draw
while operating. If an AC-powered device is used that
has an electric motor, such as a vacuum cleaner or
electric drill, the device should have a “motor load plate”
mounted on it. The motor load plate lists the current that
the device draws while operating.
C34_Coupe.indb 98
2/8/2018 3:42:53 PM
Содержание C34 Coupe 2018
