Page 2 of 5
52 Voyager Setup
Part Number 9992007 1/07
52 Voyager Setup
Hold sika to top edge around pilothouse.
Sika
Sika
b. Pull coiled water drain hoses down through
holes in bridge and route through holes in black
air intake vents.
c. Attach hoses to thru-hull fittings on port and
starboard side of boat in aft engine compartment.
After bridge is set and secured.
6. Set bridge with front touching and back 2-3" up.
Install front 3 bolts over windshield. You may have
to use a bottle jack on lower helm to raise center
of windshield. Then set back on bridge down
without pinching hoses/wires.
7. With bridge set down in place, begin securing it
with fasteners supplied in MAC kit.
a. Start by pulling down side bolsters in
pilothouse.
b. Install bolts (2 port and 3 starboard).
c. Install screws above salon door from outside.
d. When secured, seal all around pilothouse
opening inside.
e. Finish securing aft and reinstall bolsters, starting
from port to star board with windshield bolsters.
NOTE:
See drawing for screw locations and
quantities. Also, apply sealant to each individual
screw before installing it.
Picking with crane
