Version 02.10.2015
NA-VL2DVD900
Pa
ge
19
Symptom
Reason
Possible solution
Camera input picture
black.
Camera power taken directly
from reverse gear lamp.
Use relay or electronics to "clean" reverse gear lamp
power. Alterna
ti
vely, if CAN-bus box is compa
ti
ble
with the vehicle, camera power can be taken from
green wire of 6pin to 8pin cable.
Camera input picture
has distor
ti
on.
Camera input picture
s
etti
ngs cannot be
adjusted.
Camera input picture s
etti
ngs
can only be adjusted in AV2
mode.
Set dip 3 of video-interface to ON (if not input AV2 is
not already ac
ti
vated) and connect the camera to AV2.
Switch to AV2 and adjust s
etti
ngs. Reconnect camera
to camera input and deac
ti
vate AV2 if not used for
other source.
Not possible to switch
video sources by OEM
bu
tt
on.
CAN-bus interface does not
support this func
ti
on for
vehicle.
Use external keypad or cut white wire of 6pin to 8pin
cable and apply +12V impulses for AV-switching.
Pressed too short.
For video source switching a longer press of about 2.5
seconds is required.
Not possible to switch
video sources by
external keypad.
SW-version of interface does
not support external keypad.
Use OEM-bu
tt
on or cut white wire of 6pin to 8pin
cable and apply +12V impulses for AV-switching.
Interface does not
switch to camera input
when reverse gear is
engaged.
CAN-bus interface does not
support this func
ti
on for the
vehicles.
Cut the green wire of the 6pin to 8pin cable and apply
+12V constant from reverse gear-lamp signal. Use
relay to "clean" gear lamp power.
Interface switches
video-sources by itself.
CAN-bus interface
compa
ti
bility to vehicle is
limited.
Cut the grey wire of 6pin to 8pin and isolate both
ends. If problem s
ti
ll occurs, addi
ti
onally cut the white
wire of 6pin to 8pin cable and isolate both ends.
10R-03 5384
6.
Teknisk support
Bjarne Kristensen
Salg og support
Autoelektriker 1977
Selvstændig siden 1990
Mobil: 60 40 68 68
E-mail : [email protected]
