Carson x4 Micro Quadcopter, Инструкция по эксплуатации

Страница: 39 / 44

39 CARSON x4 Micro Quadcopter 500507056
GB
Please read this before something happens.
Problem Cause Reparation
The model does not move 1. Check whether the transmitter and the receiver
are switched on
Switch transmitter and/or receiver on
2. Check the battery voltage of transmitter and receiver Employ completely charged batteries
3. The trim slider of the throttle control stands on the
upper
stop
Ensure that the trim slider is in neutral position
or somewhat below
Motor does not turn 1. Motor is defective Exchange the motor
2. Motor is too hot Allow the motor to cool down
The model reacts
incorrectly to the control
commands or flies
choppily Check the state of the transmitter and receiver battery
charges Employ completely charged batteries
The model does not
take off 1. Rotor blades are twisted Exchange the rotor blades
2. Motor is too hot Allow the motor to cool down
3. Batteries are empty Charge the batteries or exchange them
The rotors do not allow
shut down Trim is not correctly adjusted Correct the trim on the pitch controller
The model moves forward/
backward and sidewise, but
does not hover Check whether the quadcopter is exposed to a draught, e.g.
by an opened window or an air conditioner. Hover flight is
not possible when there is a draught Close the window/door, switch off the air
conditioner or select a more suitable room
The model vibrates severely 1. Check whether the rotors run true Possibly change the rotor blades
Transmitter and quadcopter
can not be binded Throttle control not set to minimum Throttle need to be minimized to zero
LCD transmitter not showing
the setting interface after
hold down the joystick for 1
seconds and take off again Throttle control not set to zero Set throttle control to zero
Gyro not working well 1. Battery voltage is to low Fully charge battery
2. Re-binding Switch transmitter and model on and off
3. Gyro resetting Land on to the ground for 3 seconds and take off
again
Unable to Flip 1. Power not enough Akku vollständig aufladen
2. Press the cyclic joystick one time to enter into the expert
(flip)
mode
In the expert (flip) mode, the sensitivity on each
channel should be above 90%, you can program
the sensitivity in setting, please check manual
article „f.“ Sensitivity set up.
Can not take off Wrong installation on rotors, rotors mark with A, B. Mount the propeller as shown below
p. Troubleshooting
White B White A
Black A
Black B
Back
Front