SA-430 Installation and Operating Instructions Page 9
03/22/02 CP4854B
Cutout Input Connection
- The Cutout Input turns
off any siren tone output when activated, and
remains off until a control is activated or changed.
The adjacent diagram shows two connection
examples. See the INSTALLER-SELECTABLE
OPTIONS section for programming details.
SIREN TESTING
Before re-connecting the battery in the vehicle make sure that the siren is turned off. Observe
polarity when re-connecting.
Caution: Hearing protection should always be used when testing any siren, especially
indoors. The sound levels produced by the speakers may cause hearing loss.
The following procedure should be used to test the siren:
1. With the function selector set to the Horn position turn on the power switch. Nothing
should be heard from the speakers.
2. Press the Siren button. The speakers should emit a simulated Air-Horn sound while the
button is pressed. (If the auxiliary lead is used check the appropriate switch and/or horn-
ring operation. The result should be the same.)
3. Test the microphone operation by pressing the microphone button and speaking. The
noise-canceling microphone should be held close to the lips for proper operation. Use
the volume control to adjust the sound level.
4. If the Radio input leads are connected test this function by setting the function switch to
this setting. Adjusting a control through a hole in the amplifier sets the sound level.
Ground
switching
example
ADDED
DOOR
SWITCH
CUT
+12 Switching
example
DOOR
SWITCH
+12
CUT
SPLICE
DOME
LIGHT