CARSON Reflex Stick Ultimate Touch 500501002
84
GB
Sensors/modules connections explained
Telemetry module FS-SPD02
Speed recognition module (Not included)
Telemetry module FS-STM01
Temperature recognition module (Not included)
Procedure:
1. Connect one end of the 3-pin connecting cable
to the “Out” terminal of the telemetry module and
the other end to the “IN” terminal of the receiver,
or to the “IN” terminal of one of the sensors already
connected.
2. The sensor must be arranged on a flat surface
next to a rotating part such as the main gearwheel
or motor pinion or on the drive shaft. A line should
be drawn on the rotating part using a waterproof
black or white pen to identify the sensor. (Note:
Procedure:
1. Connect one end of the 3-pin connecting cable
to the “Out” terminal of the telemetry module and
the other end to the “IN” terminal of the receiver,
or to the “IN” terminal of one of the sensors already
connected.
2. Attach the temperature sensor in a desired
location (e.g. motor or ESC). You are advised to
secure this through direct contact with a strip of
adhesive tape.
The greater the colour contrast between
identifying line and rotating part, the better the
result). The distance between sensor and rotating
part should be no greater than 1cm.
3. Switch on the transmitter and the model (receiver).
“Motor Speed 2: 0 Upm” will now be displayed
on the main screen. The speed shown indicates
the revolutions per minute of the rotating vehicle
part on which the sensor is installed.
3. Switch on the transmitter and the model (receiver).
“Temperature 1: 25 0?” will now be displayed on
the main screen. The value shown indicates the
temperature of the vehicle part on which the
sensor is installed.
LE D
F S-S P D0
2
SPEE
D
2
OU T
IN
M agnet
i c
LE
D
FS-S
PD0
2
SPEE
D
2
OU
T
IN
Mag
neti
c
Propeller
Optical marker
Sensor
Optical rotation speed
telemetry module
LE D
F S-S TM
01
SPEE
D
2
OU T
IN
M agnet
i c
Electronic Speed Controller
Sensor
40A
Electronic
Speed Controller
BRUSHLESS MOTORS
EESCB140A003
-
+