Carson 500906160, Инструкция по эксплуатации

Страница: 41 / 48

41 CARSON DRAGSTER Brushless-Regler
GB
Flashing
frequency
1 2 3 4 5 6 7 8 9 10
Drag brake (%) OFF 5 10 15 20 25 30 35 40 45
11. Setting the Drag Brake (Engine Brake)
The drag brake simulates the friction of the brushes of brush motors.
• Press the SET button down until the blue LED light up 4 times. Release the SET
button again.
• The red LED start flashing. This shows that you are in the mode for setting the
parking brake.
• Press the SET button repeatedly until you reach the required setting.
The red LED flash at the next highest speed.
• By repeatedly pressing briefly on the SET button you can scroll through the
settings.
• When you reach the required setting, hold down the SET button for approx. 2
seconds; the setting is stored.
• Once you have stored the setting, the red and blue LEDs flashes alternate 3
times to show that you are leaving the programming mode. Switch controller
off and on again to activate the selected settings.
• If you do not press the SET button for more than 10 seconds the
controller reverts to the last setting and is ready for use again.
Blue LED
Red LED