– 19 –
38-EN
37-EN
9
Advanced settings
Case with wired remote controller
How to set up swing type
1
Push
for at least four seconds when
the air conditioner is not working.
•
, symbol, and numbers flash.
2
Select an indoor unit to be set by pushing
(left side of the button).
•
Each time you push the button, unit numbers
change as follows:
The fan of the selected unit runs and the louvers
start swinging.
3
Select a swing type by pushing TIME
buttons.
CAUTION
Do not set the swing setup code to “0000”.
(This setting may cause a failure of the louvers.)
4
Push the
button.
5
Push the
button to finish the setting.
2
1
4
5
3
Swing setup code
Swing of louvers
0001
Standard swing
(Factory default)
Dual swing
0002
Cycle swing
0003
Not
display
Unit No.
1-1
Unit No.
1-2
Unit No.
1-3
Unit No.
1-4
Swing setup code
8
Wireless remote controller A-B selection
Using 2 wireless remote controllers for the respective air
conditioners, when the 2 air conditioners are closely installed.
Wireless remote controller B setup
1. Push the temporary operation button to start the air
conditioner.
2. Point the wireless remote controller at the indoor
unit.
3. Push and hold
button on the wireless remote
controller by the tip of the pencil.
“00” will be shown on the display.
4. Push MODE button during pushing
. “B” will
be shown on the display and “00” will be disappear
and the air conditioner will turn OFF. The wireless
remote controller B is memorized.
NOTE
•
Repeat above step to reset wireless remote controller to be
A.
•
The wireless remote controllers do not display “A”.
•
The factory default of the wireless remote controllers is “A”.
CHK
CHK
“B” Display
“00” Display
1115350277.indd 20
9/27/2018 8:57:14 AM
