Carrier RGAP Series, Инструкция по установке и эксплуатации

Страница: 5 / 12

RGAP(A,B)XX: Installation and User Instructions
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
5
14. Close the unit ( Fig. 10 ). Verify latch is closed.
15. To test for proper operation:
a. Install the filter cartridge in the correct orientation. Follow the
steps per (To replace the Return Air Purifier filter cartridge,
complete the following steps: on p7) .
b. Turn on the unit; verify the green LED is active ( Fig. 17 ).
c. If the unit does not operate as expected, refer to
(TROUBLESHOOTING on p9) .
A200501
Fig. 10 – Verify Closed Unit is Latched Securely
16. If additional dust generating construction will take place after
verifying unit for proper operation, switch off the air purifier,
remove and store the filter cartridge. Install the temporary
construction filter on the safety screen using the tape provided
( Fig. 11 ).
A200502A
Fig. 11 – Construction Filter
17. After all construction is complete, remove the temporary
construction filter.
18. Install the filter cartridge ( Fig. 13 ) in the correct orientation. Follow
the steps per (To replace the Return Air Purifier filter cartridge,
complete the following steps: on p7) , and switch on the air purifier.
IMPORTANT: Make sure the metal tabs on the leading edge of the
filter case are inserted first. They must not be visible after the filter is
installed. Follow the instructions printed on the filter cartridge ( Fig. 12 ).
Otherwise, the unit will not operate properly.
A200508
Fig. 12 – Filter Cartridge Orientation
19. Close the unit and verify latches are secure ( Fig. 10 ).
A200500
Fig. 13 – Install New Filter Cartridge
20. Turn on the unit and test for proper operation; verify the green LED
is active ( Fig. 17 ).
21. If working properly, install a 20" x 30" hinged return air decorative
grille cover (provided by installer). Use the grille cover
manufacturer’s instructions. Make sure the purifier has enough
clearance to hinge down through the opened grille cover frame
( Fig. 14 ).
22. Press the applicable logo badge into the two mounting holes on the
lower left corner of the lowered unit ( Fig. 14 ).
A200503
Fig. 14 – Decorative Grille Cover and Logo Badge
SEAL WITH INCLUDED TAPE
LOGO BADGE
PLACEMENT