Carrier OptiClean FN1AAF, Руководство по эксплуатации и обслуживанию, Страница: 2 / 8

FN1AAF: Operation and Maintenance Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
2
About the OptiClean™ Air Scrubber
The OptiClean™ uses highly efficient filters and a heavy duty, yet quiet,
motor to pull the air in, remove over 99% of contaminants, and discharge
cleaner air back into the room.
NOTE: While removing your unit from its packaging, inspect it
carefully. If damage is noted, contact your shipping carrier and file a
claim.
Tools Required
• Box cutter
• 5/16ʺ (8 mm) socket or wrench
• Drill or powered driver
Assemble the Unit
1. Before removing the shipping straps, put the crated unit on its back.
Use two persons if necessary.
2. Remove the straps, then remove the cardboard coverings and
wooden skid.
3. Remove the bottom front door, then the top door over the blower
section.
4. Inspect the HEPA filter and make sure it has not been dislodged or
damaged during shipping, and:
• the side bolts and nuts near each corner are tight and the HEPA
filter is held securely in place
• the seal around the top edge of the filter is in place
5. Remove the flat piece of cardboard from between the pre-filter and
HEPA filter.
6. Make sure the pre-filter is in place and not damaged.
7. Remove the carton of parts from the lower section. You may need
to tilt the carton to get it out.
8. Replace the top door over the blower, then the bottom front door.
NOTE: The unit can be operated without casters, on its back in a
horizontal orientation, as long as there is sufficient space at either end for
air intake and output. Make sure to properly strap or otherwise secure it
to a base to avoid unintentional movement.
When the unit is mounted horizontally, an additional pre-filter must be
used. See Table 2 .
9. Attach the caster assemblies (ref Fig. 2 ) to the bottom of the unit.
a. Remove and retain the screws from the outer corners of the
cabinet bottom.
b. Position the caster assembly along the front outer edge of the unit
and line up the screw holes.
c. Use the removed screws to attach the caster assembly.
d. Repeat for the other side.
A200233A
Fig. 2 – Boxed Casters and Duct Transition (10-inch round shown)
10. Use the included screws to attach the round or oval duct transition
plate to the top of the unit ( Fig. 3 ). An optional air diffuser
(KFADG0101SML/LRG) is also available, which has its own
installation instructions.
11. Carefully lift the unit to a vertical position on its casters.
HINT
: Lock the casters before lifting or tilting up the unit.
12. Move the unit to its final position and lock all four casters.
13. Plug the unit into a grounded 115V outlet.
A200218A
Fig. 3 – Typical Duct Transition Installation
Table 1 – Horizontal Configuration Pre-Filters (cartons of 12)
OptiClean Model Pre-Filter Part No.
FN1AAF005, FN1AAF006 KFAFK0212MED
FN1AAF015 KFAFK0312LRG
WARNING
!
TIP OVER HAZARD
Failure to follow this warning could result in personal injury and/or
property damage.
Unit must be on a smooth and solid surface. When moving the unit:
- make sure the path is free of obstacles
- make sure the wheels are unlocked
- place hands around the center of the unit and move slowly